AeManual / USUBOCTAVE

┬ÁSUBOCTAVE

View Product Page

This 1/3 height micro module creates 2 outputs of square waves, one and two octaves below the incoming signal. It also produces another output 2 octaves below the incoming signal with a Pulse wave. There is also a mix output where the levels of the additional sounds can be controlled and combined with the original signal.

This module needs to be installed on the ┬ÁBASE module!

Module power consumption: ? mA

Inputs

  • IN - The incoming audio signal.

Outputs

  • MIX - The mix of the original signal plus the one and two octave sub octave signals. Using the knobs you can adjust the level of each of the suboctave signals in the mix.
  • -1 SQR - The full level output of the one octave square wave signal
  • -2 SQR - The full level output of the two octave square wave signal
  • -2 SQR - The full level output of the two octave pulse wave signal

Controls

  • -1 OCT. - adjusts the level of the one octave signal in the mix.
  • -2 OCT. - adjusts the level of the two octave signal in the mix.

Patch Suggestions

uSUBOCTAVE

<-- Back to the Module Index

This manual is a community work in progress. If you would like to help out with completing this manual please send a PM to @admin at the AE Modular Forum. The status of each page can be seen on the Trello board at https://trello.com/b/HNd0dBt7/ae-manuals



Page last modified on September 01, 2022, at 06:49 AM
Powered by PmWiki